Josephine's Rainbow

The challenge for this fortnight is Make it Green.

I decided to have a go at various techniques which are new to me, and while I'm happy with the result, there are things I'll do differently next time.

I started with a die from Eileen Hull/Sixxix: the Travel Journal. Now, this die does give a very tall, narrow journal in its original form, so I followed a tutorial from Eileen on how to make it a bit wider. For me, it's still rather narrow, but it's definitely an improvement on the original. I think the reason for the odd shape is that Eileen always restricts herself to designing for small die cutters, so this die will go through a basic Big Shot. I do wish she's design for bigger machines and give us something that takes standard size paper: A4 or A5. But still. Her suggestion is to cut a back and front as usual, but instead of using the scored edges to form a spine, you cut an extra bit and put the spine scores and holes at both edges, which is what I did here.

Before cutting, I covered some grey board with Kraftex on one side only. Then, I coated the Kraftex and back sides with gesso. This is definitely something I'd do differently. The Kraftex probably doesn't need the gesso, and the grey board absorbed quite a lot so the pieces had a distinct curve which, while not a visual issue (to me) meant that attaching the three pieces was problematic. But, I'm getting ahead of myself.

After the gesso, I used a gelli plate to apply distress oxide inks to give an overall greenish shade. (I only have a few of these inks, and none of them is green!) Then, I used stamps and inks (mainly Memento) on the front and back inside and out.



I was playing, so I've used a range of stamps and stamping techniques. The inside uses repeating background stamps from Inkylicious. The front uses a lace rubber stamp for which I have no record of the manufacturer, and the back, stamps from Printable Heaven, I think.

Although its not obvious, I added a piece of lace to the centre of the front. I used Modge Podge for this, and because the inks I used were water based, there was some transfer, so the lace definitely matches the rest!  To finish the front, I added some lacy flowers cut using Tattered Lace dies. I used Coredinations card and gently sanded the pieces before sticking them, again with Modge Podge. I used Modge Podge over everything as a sealer before assembling the pieces.

Here, I found that glue wasn't going to work, at least, not on its own. So, I used the otherwise unused punched holes in the front and back covers and spine to reinforce the structure with thread.


You can just see the thread in this photo.

Because I'm using the die cuts in a way that was not intended, I had to manually punch holes in the spine for attaching pages inside and a further one so I can add an elastic closure when that becomes necessary.
And to give an idea of the inside, I've put a single double-sheet in each of the four elastic holders.

Next time, I'll probably revert to covering the inside of the cover with paper rather than using gesso. That should make it easier to assemble the journal, but I might still use the reinforcement technique!

I hope you can join us this time.